Changing The Select Keys - G&D TradeSwitch2-USB Assembly, Installation And Operation Manual

Changing the select keys

In the default settings, use the enabled select keys
computers that are connected to the KVM switch.
For instance, you can switch to computer 2 by pressing
How to choose a different select key set:
1. Press Hotkey+Backspace
mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys shown below to activate the desired set of select
keys to switch the computers 1 to 2:
1  Enables select keys 1 and 2
 Enables select keys NUM 1 and NUM 2
NUM 1
Z  Enables select keys A and B
F1  Enables select keys F1 and F2
1. Use the terminal emulator to establish a connection to the KVM switch.
2. Use the Arrow
3. Press the Space
switch the computers 1 to 2:
 Enables select keys 1 und 2
1 ... 2
 Enables select keys NUM 1 und NUM 2
NUM 1 ... 2
A ... B  Enables select keys A und B
 Enables select keys F1 und F2
F1 ... F2
4. Press the S key to save your settings.
(default: Alt Gr+Backspace
or Arrow keys to select the
key (repeatedly) to enable the particular set of select keys to
Configuration
and to switch between the
1 2
Hotkey+2 (default:
) to enable the setup
Select Key row.
G&D TradeSwitch2-USB · 22
Alt Gr+2 ).