Switching Via Serial Device - G&D TradeSwitch2-USB Assembly, Installation And Operation Manual

Switching via serial device

The channels can be switched via a serial device connected to the RS232 port of the
KVM switch. The serial device can be either a special keypad or a computer which
is terminal emulator operated.
IMPORTANT:
Use the following connection settings and the switching commands of
the KVM switch to successfully switch the channel with a serial end device.
Connection settings
Use the following connection settings for the serial end device to establish a serial
connection to the KVM switch.
 Bits per second:
 Data bits:
 Parity:
 Stop bits:
 Flow control:
Switching commands
The following commands are provided for switching between channels:
Command
1!
2!
<!
>!
ADVICE: Use the » ?! « command to show the currently accessing channel.
NOTE: The serial device carries out the command directly after it is sent.
A message (see below) informs the serial device if switching between channels
was successful.
115.200 (see page 32)
8
none
1
none
Channel
1
2
Switch to previous channel
Switch to next channel
Switching
G&D TradeSwitch2-USB · 12