Installing The Front Mezzanine Gpu Module - Cisco UCS X10c Installation And Service Manual

Installing the Front Mezzanine GPU Module

What to do next
Connect the front mezzanine GPU module to the compute node.
on page 8
Installing the Front Mezzanine GPU Module
To install the front mezzanine GPU module, you will insert screws on the side of the compute node's sheet
metal tray and on the node's motherboard.
Use the following task to install the X10c front mezzanine GPU module.
Before you begin
Review
Step 1 Holding the front mezzanine module by the center of the top edge, keep the module level, and lower it down onto the
compute node (1).
Step 2 Align the rear captive screws with the threaded standoffs (2).
The motherboard has guide pins that assist with installing the module onto the compute node. Use these guide
Note
pins while installing the module.
Cisco UCS X10c Front Mezzanine GPU Module Installation and Service Guide
8
Cabling Considerations, on page 12
Installing the Front Mezzanine GPU Module,
for important information before beginning this task.
Installing the GPU Module