The Charging Station - Husqvarna Automower 115H Workshop Manual

4. Fit the upper chassis to the lower chassis and fasten
the 12 screws (Torx 20).
CAUTION: Fasten the screws crosswise.
5. Fit the cutting height adjustment knob.
6. Refit the STOP button into the clips. Refer to
disassemble the upper chassis on page 18 .
7. Reassemble the body into the 4 positions on the
lower chassis. Refer to
system on page 16 .
8. Refit the hatch into the clips. Put the frame into
position (not for Husqvarna
9.
®
a) For GARDENA , Flymo
the top cover into position.
b) For McCULLOCH
2 screws into the body.
6.15.1 To replace the sealing strips
There are 2 sealing strips between the upper chassis
and lower chassis in the product. One between the
center console and the upper chassis and one between
the lower and upper chassis. Both sealing strips must be
replaced using the same technique.
CAUTION: A 5 mm sealing strip must be used.
Sealing may be deficient if the wrong sealing
strip is used.
1. Start by laying one end of the sealing strip in line
with the marking on the chassis.
2. Continue laying the sealing strip clockwise around
the lower chassis.
28 - Repair instructions
To
To disassemble the body
®
).
® ®
and Husqvarna
®
, fasten the top cover with the
3. Lay the other end of the sealing strip above the first
end and then out of the channel. Fasten the sealing
strip in the retainer.

6.16 The charging station

6.16.1 To replace the charging tower
The charging tower consists of the contact plates and
the charging station's circuit board. These cannot be
replaced separately. The entire charging tower must be
replaced as a unit.
When the product's battery does not recharge or cannot
contact the charging station, this may be due to worn
contact plates in the charging station. Also check the
charging plates on the product.
1. Disconnect the power supply.
2. Disconnect all cables from the charging station.
, push
3. Remove the charging tower by pushing the 2 clips
and pull it up.
1413 - 003 - 17.01.2022