Husqvarna Automower 115H Workshop Manual page 39

Messages
Number Message
69 Alarm! Mower switch-
ed off
70 Alarm! Mower stopped The alarm was started because the
71 Alarm! Mower lifted
72 Alarm! Mower tilted
75 Connection changed
76 Connection NOT
changed
77 Connectivity problem
78 Slipped
81 Safety function faulty
119 Zone generator prob-
lem
ZoneProtect problem
1413 - 003 - 17.01.2022
Cause
The alarm was started because the
product was switched off.
product was stopped.
The alarm was started because the
product was lifted.
The alarm was started because the
product was tilted.
The loop signal was successfully
changed.
Failed to change the loop signal.
These is a problem with the communi-
cation circuit board in the product.
The product has hit an obstacle and
stopped or the wheels cannot move on
the wet grass.
The work area includes a steep slope.
The guide wire is not laid at an angle
on a slope.
The indicator lamp on the keypad is de-
fective.
The battery of the ZoneProtect acces-
sory is low. The ZoneProtect accessory
does not operate when the battery is
empty. The product can cut in the stay-
out zone if you start the product before
you charge the ZoneProtect accessory.
The temperature in the ZoneProtect ac-
cessory is a higher than the maximum
limit and is set to off.
Action
Enter the PIN code to disable the
alarm.
No action.
Try several times to create a new loop
signal. If the problem remains, replace
the main circuit board. Refer to
ate a new loop signal in the Operator's
To replace the main circuit
manual and
board on page 20 .
Restart the product. It can be a tempo-
rary problem, try to restart again in 30
minutes. If the problem stays, examine
the communication circuit board and
replace if necessary. Refer to
place the communication circuit board
®
for GARDENA products on page 22 .
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Check the maximum guaranteed slope.
Steeper slopes should be isolated.
Lay the guide wire at an angle across
the slope.
Restart the product. Examine the key-
pad, the main circuit board and their
cabling. Replace if necessary. Refer to
To replace the keypad on page 25 , To
replace the main circuit board on page
20 .
Park the product and charge the Zone-
Protect accessory before you start the
product.
Put the product in an area with protec-
tion from the sun. Let the temperature
of the ZoneProtect accessory decrease
before you start the product.
Troubleshooting - 39
To cre-
To re-