Symptoms - Husqvarna Automower 115H Workshop Manual

Messages
Number Message
NA Needs manual charg-
ing
Next start hh:mm

8.2 Symptoms

The most commonly occurring symptoms are described below. All symptoms are grouped by the situation where they
occur most often.
1. Mowing
2. Searching
3. Following the guide wire
4. Docking
Note: Refer to the Operator's manual for more information about how to rectify errors.
8.2.1 Symptoms during mowing
Symptom
Uneven mowing results
The product runs at the wrong
time
The product vibrates
The product mows for short-
er periods than usual between
charges
1413 - 003 - 17.01.2022
Cause
The product is set to the
area operating mode.
The timer setting prevents the product
from operating.
The products clock is incorrect.
Cause
The product works too few hours per day. Increase the working hours.
Working area too large.
Blunt blades.
Long grass in relation to the set cutting
height.
Incorrect lawn coverage settings.
Does not follow the guide wire to the
areas specified.
Accumulation of grass by the blade disc
or around the motor shaft.
SensorControl/Lawn shield/LawnSense
reduces the mowing time too much.
The start and stop times for mowing are
incorrect.
SensorControl/Lawn shield/LawnSense
reduces the cutting time.
Wrong number of blades creates an im-
balance.
Grass or a foreign object is blocking the
blade disc or wheels. The cause may al-
so be lower battery capacity.
Action
Secondary
Put the product in the charging station.
This behavior is normal and no further
action is required.
Change the timer settings.
The products clock is incorrect.
5. Charging
6. Miscellaneous
Action
Try to limit the working area or extend the
working time.
Replace all the blades and screws so
that the rotating parts are balanced.
Increase the cutting height and then
gradually lower it.
Check the lawn coverage settings and
optimise them for the installation.
Check the guide signal. Refer to
Info on page 8 .
Check that the blade disc rotates freely
and easily. If not, the blade disc may
need to be removed and grass and for-
eign objects removed.
Check and change the settings. Refer to
Operator's manual.
Adjust the start and stop time settings for
mowing.
Check and change the settings. Refer to
Operator's manual.
Make sure there are no blades missing or
that more than one blade is mounted on
the same screw.
Remove and clean the blade disc. Per-
form a battery test to determine the bat-
tery's capacity. Refer to
page 45 .
Tools -
Battery test on
Troubleshooting - 41