To Mount Screws In Plastic; To Mount Thread Plugs - Husqvarna Automower 115H Workshop Manual

4. The cap is attached with one clip. Remove it by
gently lifting one side of the cap.
5. Fit the cap to the new charging tower.
6. Refit the charging tower on the baseplate.
7. Connect all cables to the charging station.
8. Connect the power supply.

6.17 To mount screws in plastic

CAUTION: If the screws are mounted
incorrectly, there is a risk of damaging the
threads in the plastic and thereby shortening
the service life of the plastic part. If threads are
destroyed, the part must be replaced or thread
plugs can be inserted. Refer to
plugs on page 29 .
CAUTION: When assembling parts in plastic,
always tighten the screws crosswise. This is to
avoid tension in the plastic, causing malfunction
or not attaining a satisfactory seal.
1413 - 003 - 17.01.2022
To ensure the threads in plastic parts are not damaged:
1. Carefully turn the screw counter-clockwise until it
1
2. Tighten the screw to the correct torque as specified

6.18 To mount thread plugs

If the threads in plastic parts are worn, thread plugs
can be inserted. A repair kit containing thread plugs and
suitable metal screws is available to order.
To mount thread
To mount a thread plug into a worn plastic thread:
1. Make the hole bigger with a 6.6 mm drill to a depth
2. Mount the thread plug with the screw that comes
engages the existing threads in the plastic. The
screw will fall slightly by itself when the threads are
located correctly in relation to the existing threads in
the plastic.
2
Screw fasteners on page 32 .
in
CAUTION: Fit the thread plug carefully since
there is a risk that the screw bosses crack.
corresponding with the plug.
with the repair kit and screwdriver.
½
3
Repair instructions - 29