Panasonic KV-S6055W Service Manual page 81

Classified Error
Code Code
22 00 00 00 U34 Error Code does not turn off even
U34
25 00 00 00 U35 Error Code does not turn off even
U35
30 xx 00 00 The Hopper Home Sensor does not
F40
F50 00
40 00
|
|
F78
| |
00
4F 00
80 00 00 00
F10
81 xx xx xx Poor soldering around the Work RAM
F11
85 00 00 00 Download to Imprinter has failed.
F15
87 00 00 00 Poor soldering around the SD-RAM
F17
88 00 00 00 Additional DIMM is not mounted
F18
89 00 00 00
F19
8A xx xx xx Shading RAM Error
F20
8B xx xx xx Line RAM Error
F21
90 xx xx xx Patch RAM Error
F26
92 xx xx xx Rotation RAM Error
F28
93 xx xx xx Front Gamma RAM Error
F29
94 xx xx xx Back Gamma RAM Error
F30
95 xx xx xx Dither RAM Error
F31
98 xx xx xx EEPROM RAM Error
F34
9A xx xx xx GA Sensor Error
F36
9B xx xx xx GA Image Error
F37
(Note)
If neither LCD indication nor memory accessed from CPU work properly, when initializing, LED6
Possible Cause
through the Back Door is closed.
1. The connector to the Back Door Detector is loosen.
2. The Back Door Detector is broken.
through the Document Cover is closed.
1. The connector to the Document Cover Sensor is
loosen.
2. The Flat-Bed Door Detector is broken.
operate properly.
1. The connector to the HOPPER POSITION DETECTOR
Board is not properly inserted.
2. The Hopper Home Detector is broken.
1. Paper dust on the sensor section.
00
2. LED or sensor is laid down.
3. LED has reached the end of its useful life.
|
00
1. Program ROM is not correctly mounted.
2. Download has failed.
(IC1029, IC1030) on the MAIN CONTROL
Board. (ST2: DATA) (ST3, 4: Address)
(IC604, IC605) on the SCSI Board.
correctly.
1. Connect the cables properly.
2. Replace the sensor board.
1. Connect the cables properly.
2. Replace the sensor board.
1. Mount the connector properly.
2. Replace the HOPPER POSITION DETECTOR
1. Clean the sensor section.
2. Straighten the LED or sensor.
3. Replace the LED.
1. Remount ROM correctly.
2. (1) Download again.
(2) Replace the Program ROM or the MAIN CONTROL
Board.
Replace the MAIN CONTROL Board.
1. Replace the IMPRINTER Board.
2. Confirm the cable connected to IMPRINTER
3. Confirm MAIN CONTROL Board Imprinter I/F
Replace the SCSI Board.
Remount the DIMM.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board.
Replace the MAIN CONTROL Board
SCSI Board.
81
Check Point