Panasonic KV-S6055W Service Manual page 75

9.4.4. Other Setting Mode (Normal Mode 4)
No Item
Version (Disp. firmware
1
version)
Buzzer
2
3 SCSI-ID
4 Terminator
5 Transfer Rate
6-a Clean Roller (Disp. %)
6-b Clean Roller (Clear
warning for "Clean
Roller")
7-a Replace Roller (Disp. %)
7-b Replace Roller (Clear
warning for "Replace
Roller")
8 Product ID KV-S6055W
series
KV-S6050W
series
9 Sleep Mode (Set period
to enter in Sleep Mode)
Note:
- If the scanner is the last device in the SCSI chain, then the
terminator should be set to "Enable". But, under the above SCSI
chain and scanner's turn-off, the terminator should be attached to
the SCSI connector on the scanner.
- Setting the SCSI ID will be activated after turning the power OFF
and turning it ON again.
- Setting the terminator will be activated after turning the power OFF
and turning it ON again.
9.4.5. Service Setting Mode (Service Mode 1)
OFF ON
No. 0~7
Dis- able Enable
20MByte 10MByte
/sec /sec
~%
Clear <>
~%
Clear
KV- KV- KV- KV-
S6055 SS855 S2065 S2055
KV- KV- KV- KV-
S6050 SS855 S2065 S2055
Dis- able After 1
min~ 60
min
Setting Contents
KV-
S6045
KV-
S6040
75
Default Factory
Setting
- -
ON ON
6 6
Enable Enable
20MByte/ 20MByte/
sec sec
0% 0%
- -
0% 0%
- -
KV-S6055 KV-S6055
KV-S6050 KV-S6050
15 min 15 min