Panasonic KV-S6055W Service Manual page 12

5. Press the SELECT [
setting.
The [ ] key moves to the next content as shown below.
The [ ] key moves to the previous content.
Note:
- If the scanner is the last device in the SCSI chain, then the
terminator should be set to "Enable". But, under the above SCSI
chain and scanner's turn-off, the terminator should be attached to
the SCSI connector on the scanner.
- Setting the SCSI ID will be activated after turning the power OFF
and turning it ON again.
- Setting the terminator will be activated after turning the power OFF
and turning it ON again.
5. SECTIONAL VIEWS
5.1. Motors (Front View)
5.2. Optical Units and Imprinter
5.3. Rollers
5.4. Drive Belts
5.5. Circuit Boards
5.6. Sensor Boards and Switches
6. MECHANICAL FUNCTION
6.1. Paper Feed Mechanism
] key or [ ] key to select the desired
Fig. 6-1
12