Panasonic KV-S6055W Service Manual page 14

4. When the top of the paper passes through on Size Sensor via
Separation / Retard Roller and Conveyor Roller, Paper motor stops.
5. When the top of the first page reaches to Scanning Position, CCD
sensor and or CIS is driven to scan. And by using the above
sensors, scanning process starts.
6. When the end of the paper passes through on CIS(Back Side
Scanning Position), Conveyor Motor stops, Scanner waits for next
scanning start command from PC. At this time, if no following
paper to scan, the current scanning paper is gone out.
7. When the end of the first page passes through on the Size Sensor
on the continuous scanning mode, Paper Feed Motor starts again
after an interval of approx. 100mm on duplex mode(approx.60mm
on simplex mode) and feed the following paper through the
conveyor section.
8. Repeat the above (3) to (8).
9. After finishing all scanning process, Hopper goes down to the
original position and the series of Scanning sequence ends.
6.2. Manual Feed Mode
1. For multiple sheet's scanning, there is possibility that the first
page and the second page will be separated, and the paper will be
torn if paper is scanned while the Retard Roller is locked.
14