edge of a table.
- Do not turn it upside down or stand it on its side.
- When placing the scanner on a table, be careful not to extend
beyond the edge 15cm (5.9"). Otherwise, the scanner may fall.
(2) Remove the metal clamp on the bottom of the scanner from position (A) and attach it at
position (B) instead.
4.3. DIMM Module Extension
A maximum of 256 MB extended memory may be required depending on the combination of the
paper size, resolution and gray scale mode.
(For example, to scan a two-sided A4 size document with 600 dpi, gray, etc.)
To determine how much extended memory is required, refer to the section 4.6.1 "Additional
Memory Size each scanning mode (MB)".
* Recommended DIMM
- JEDEC-standard 168pin, dual in-line memory module (DIMM)
- Non buffered
- Single +3.3V±0.3V power supply
- Frequency/ CAS Latency : 100MHz/CL=2, 133MHz/CL=2, 133MHz/CL
5