Return Of Old Electric And Electronic Equipment For Disposal; Maintenance And Care; Customer Information - 3M ESPE Pentamix 3 Operating Instructions Manual

SEITE 8 - 210 x 297 mm - 44000180602/02 - SCHWARZ - 12-211 (sr)
Malfunction Cause
The cartridge cannot Plungers are not in the
be inserted into the uppermost position
unit
The cartridge
receptacle is dirty
Plungers cannot Cartridge not inserted
be moved into the correctly
cartridge
Plunger disc defective
The unit does not The "Start" button is
switch off when jammed
the "Start" button
is released
Hand wheels are Foil of a bag is wedged
difficult to turn back between the cartridge
and the plunger
Hand wheels Pressure on foil bags
completely blocked has not been released
Operating LED does No power to the unit
not light up
Main switch has not
been turned on

7. Maintenance and Care

7.1 Replacement of the Plunger Discs
If damaged, the plunger discs must be replaced. Only original parts may be
used as replacements to insure safe operation.
Turn off the unit and disconnect the plug from the power source.
Use an Allen wrench to remove the screw in the center of the plunger
disc. Remove the disc and screw a new one into place (Fig. 26).
When changing the plunger discs, make sure you position them with the
correct alignment (see Fig. 26) to prevent damage to the foil bags.
7.2 Care
Clean all components with a soft cloth and, if necessary, a mild cleaning
agent (e. g. dish-washing detergent). Solvents or abrasive cleaners may not
be used in any case, as they can damage the plastic components!
- Cleaning agents must not enter the unit!
To disinfect all components, spray the disinfectant on a towel and use it to
disinfect the unit. Do not spray the disinfectant directly on the device.
- Disinfectant agents must not enter the unit!
- Dry residual disinfectants on the device with a soft and fluff-free
cloth, as they damage the plastic components.
If necessary, ask the manufacturer of the disinfectant if its constant use will
damage plastic surfaces.
7.3 Maintenance and Repair
No components inside the unit require servicing or repair by the user.
3M Deutschland GmbH will accept responsibility for the safety, reliability,
and correct function of the unit only if:
- Any modifications or repairs are carried out only by personnel
authorized to do so by 3M Deutschland GmbH;
- The electrical fittings in the room comply with all regulatory
requirements;
- The unit is operated according to these Operating Instructions.
Plastic cartridges are subject to wear depending on the material and
frequency of use and are therefore not covered by the warranty for this unit.
8
They should be regularly checked for signs of wear (e.g., fissures) and
Remedy
replaced with new, metal-reinforced Penta cartridges two years after initial
Use the hand wheel to
operation at the very latest. The use of worn or defective cartridges can
move the plungers up
have adverse effects on the evenness of the mixture, reducing the quality
until they stop and hold
of the impression.
Clean the cartridge
receptacle, removing
any foreign objects 8. Return of Old Electric and Electronic
Check the correct
Equipment for Disposal
positioning of the
cartridge in the
Pentamix 3 unit
8.1 Collection
Check plunger discs for
Users of electric and electronic equipment are required to collect their old
damage and replace if
equipment separately from other waste in accordance with the regulations
necessary (see 7.1)
of the specific country. Old electric and electronic equipment must not be
Pull the "Start" button
disposed of with unsorted household waste. This separate collection is
up or, if necessary,
a prerequisite for recycling and reprocessing as an important method for
use the main switch to
preserving environmental resources.
turn off the unit and free
the "Start" button
8.2 Return and Collection Systems
Run the plunger to the
When your Pentamix 3 is no longer usable, do not dispose of the device
top position against
with household waste. 3M Deutschland GmbH has set up special disposal
the resistance. Check
facilities to handle the equipment. Details about the procedure for the
the plunger discs and
specific country can be obtained from the pertinent 3M Deutschland GmbH
replace if necessary
subsidiary.
(see 7.1)
Press the "Start"
8.3 Meaning of the Symbols
button briefly (1 sec.)
The EU Directive prohibits the disposal of any electric or electronic devices
Check the connection
marked with these symbols in combination with household waste.
of the power plug at the
unit and the outlet
Turn on main switch

9. Customer Information

No person is authorized to provide any information that deviates from the
information provided in this instruction sheet.
9.1 Warranty
3M Deutschland GmbH warrants this product to be free from defects
in material and manufacture. 3M Deutschland GmbH MAKES NO
OTHER WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
User is responsible for determining the suitability of the product for user's
application. If this product is defective within the warranty period, your
exclusive remedy and 3M Deutschland GmbH's sole obligation shall be
repair or replacement of the 3M Deutschland GmbH product.
9.2 Limitation of Liability
Except where prohibited by law, 3M Deutschland GmbH will not be liable
for any loss or damage arising from this product, whether direct, indirect,
special, incidental or consequential, regardless of the theory asserted,
including warranty, contract, negligence or strict liability.
Information valid as of December 2011