Table of Contents
Advertisement
Main / Home Screen Defined-
Above is the Start-Up Home Screen-
Park Tool
= Pressing this button will put the active tool in spindle into its tool holder and leave the
spindle empty.
Preventive Maintenance Note-
*****One should never leave a tool in spindle when machine is Idle. Leaving a tool in spindle will
cause rust and damage to tool holder and or spindle.
Verify Origin
= Pressing this button will move the machine to whatever ZPO (Z-Point Origin) Coordinates
33
is selected on the Jog screen, G54-G59.
****ZPO (Z-Point Origin) coordinates – These are based on the G54-G59 set and selected from the Jog Screen.
Advertisement
Table of Contents
