Table of Contents
Advertisement
Fitting the router bit into the router head (Cont'd.)-
3.) Fit the Spindle Nut and Collet Assembly onto the Tool Holder and thread by hand.
4.) Press the bit into the Collet, please note that the flute of the Router Bit must not be inside the Collet and should be a
minimum of 1/16" outside the collet.
5.) Hold the Router Spindle and tighten the Collet with a Wrench Tool. Do not over tighten.
Note: Use this process for all other router bits that you need to fit, but you will have to change the collet if the shank of the router bit is a different size.
Note: Keep your collets clean and blow all dust out of the slots. Fine dust accumulates and will affect the clamping action.
Advertisement
Table of Contents
