Laguna Tools Smartshop Composite Fabricator 16 Manual page 16

Fitting the Router Bit into the Router Head-
Safety Note: Before changing or fitting the router bit, always disconnect the power from the machine.
1.) Select a router bit and its relevant collet.
2.) Fit the collet into the spindle nut. Press the collet into the spindle nut until it snaps into place.
Note: The router bit must not be fitted into the collet until the collet has been fitted into the spindle nut. With the router bit fitted into the collet, the collet cannot
compress and snap into the spindle nut. The face of the collet and the face of the spindle nut will be close to flush.
Note: To remove the collet, hold the spindle nut and press the collet on the side. The collet will compress and pop out. Do not try to remove the collet while a cutter is
fitted, as the collet will not compress and pop out.
Fully Assembled.