XCMG XE210C Operating & Maintenance Manual page 90

XE210C Hydraulic Excavator
rear. In this way, even the wall collapses, the machine can withdraw easily.
b) If it is necessary to work on cliff or under high bank, make sure to check working site at first and
confirm there is no possibility that cliff or bank will collapse, if there is, don't work in this area.
c) When working on soft land, the ground may collapse leading to the rolling over of the machine.
When you need to work on soft land, you must strengthen the ground at first with big steel board to
support the machine.
d) When operating on uneven ground or slope, try to prevent the happening of turning over your
machine:
1) Reduce the engine speed.
2) Choose slow treading mode.
3) Operate the machine slowly and pay attention to the movement of machine.

Guard against the falling of stones or gravels
When working in the place where there may be falling stones
or gravels, make sure FOPS(FALLING OBJECT PROTECTION
SYSTEM)cab is contained in the machine.

Move or operate the machine safely
When moving or operating the machine, the surrounding people may be
knocked down. So pay attention to:
a) Pay special attention not to knock down the people around. Before
moving, turning or operating the machine, identify the position of those
people.
Always keep the treading annunciator and horn in working state (if there are). When the machine
begins to move, they can warn the surrounding people. When the machine is treading, rotating or
being operated, the signaler should be employed and coordinate the hand signs with others before
starting the machine.

Unified signals in multi-machine work
In the case of multi-machine work, the signal known by all the working staff
must be used. One signaler should be appointed to organize the operation to
ensure all the people follow the command of this signaler.

Prevent the reversing and injury suffered from rotation
When reversing or rotating the upper machine body, if someone is near the
machine, he will be knocked down or crushed, suffered from a severe casualty.
To guard against the reversing and rotating accident:
a) Before reversing or rotating, confirm there is nobody around the machine.
b) Keep the treading annunciator and horn in working state (if there are). Always
look out if there is other person entering into working area. Before moving the
machine, please warn others with horn or other signals.
c) When reversing, if your view is blocked, please use a signaler, always keeping
Operating and Maintenance Manual 90
Fig.1-80
Fig.1-81
Fig.1-82
Fig.1-83
Fig.1-84