Road Transport; Removal Of Trailer - XCMG XE210C Operating & Maintenance Manual

XE210C Hydraulic Excavator
During the transport of machine on the road, learn of and follow all the local laws and regulations.

During the transport of trailer, verify the length, width, height and weight of trailer for loading the
machine.
Note: the transport weight and size may be different due to the type installed track plate or
front working device.

Observe the conditions of transport route in advance, e.g. size, weight limit and traffic regulations. In
case of disassembling the machine, meet the local specified size or weight limit.
Remove the machine always on the firm or flat ground.
Note: be sure to use the platform or slope during the loading and unloading.

Adopt the slope or platform.
a) Clean the slope or platform and trailer platform thoroughly before
loading and unloading, the risk of slipping may exist on them with
oil dirt, soil or ice.
b) During the use of slope or platform, place the damp block under the
wheel of front body and trailer.
c) The slope or platform must have enough width, length and strength
to make the inclination angle of slope or the gradient of platform below 15°.

Loading
a) The direction of machine is down: with front-end working device: move the working device forward
with it placed on front body; without front-end working device: travel in reverse direction as shown in
above figure.
b) The centerline of machine shall be on the centerline of
trailer.
c) Drive the machine slowly on the slope. With front-end
working
device:
1) Support the plane bucket on the trailer, and the angle
between
bucket rod and movable arm should be within 90º to 110º.
2) Upon inclining the machine to trailer platform, support the bucket to the trailer, move the machine
slowly forward, until the whole crawler moves on the trailer
and contacts the platform.
3) Lift the bucket slightly, retract the bucket rod and make it
under the machine, and rotate the upper car slowly by 180º.
4) Fall the bucket to sleeper.
d) Stop the engine, and remove the key from key switch.
e) Move the control lever several times until the whole pressure of hydraulic cylinder is released.
f) Pull the safety locking rod to LOCK (lock).
g) Close the window, skylight and door of cab, and cover the air outlet to prevent the wind and rain from
entering into it.

Road transport

Removal of trailer

Operating and Maintenance Manual 141
Fig.3-2
Below 15°
Fig.3-3
Fig. 3-4