Table of Contents
Advertisement
XE210C Hydraulic Excavator
Lift or move objects
Attention：
1)
When using the machine to lift or move objects, you must abide by all the local regulations.
Since the steel cable, strap or rope may be broken and lead to a severe casualty, so don't use
damaged chain, broken steel cable or strap or rope to lift heavy thing. Move the object slowly
and carefully. Sudden movement of load even above the person's head is not allowed. Don't let
anyone get close to the load.
2)
Ensure all the people are away from the load lifted or tied with steel cable and placed on
ground, until the load has been supported by supporting block or placed on ground stably.
Position the upper machine body perfectly and keep the treading motor at the rear. Don't
3)
connect sling/chain with bucket teeth, which may come off and result in the falling of lifted
object.
Don't let the sling entwine your hand and body.
4)
When wind speed is high, don't use sling to lift or raise originally rated weight. When the
5)
exterior area of the cargo is relatively big, watch out any kinds of gust.
a)
Bind the sling or chain tightly on the load supposed to be lifted. When binding the sling or chain,
make sure to wear gloves.
b)
Turn the bucket and withdraw the bucket lever, connect the sling or chain with bucket ring. Before
starting, hand signs must be coordinated with the signaler.
c)
Know very well the position of all the working staff in working site.
d)
Connect hand-pulling rope with the load and ensure the puller is far away
from the load.
e)
Before the lift, measure the load weight and lift up.
1)
Lift the load to the height of 50mm away from the ground or lift it only to
demanded height.
2)
Let the load go around nonstop to one side.
3)
Keep the load close to the ground and take it away from the machine.
f)
If there is any unstable phenomenon, lower the load immediate down to the ground.
The operation of hammer-style knapper
As the picture, if there is hammer-style knapper in the machine, operate it with operating pedal front
and right to the seat.
Attention: when not using the hammer-style knapper, you must lock operating pedal with pedal
lock.
Other operating procedures
Operating and Maintenance Manual 100
Fig.1-100
Hide quick links:
Advertisement
Table of Contents
