XCMG XE210C Operating & Maintenance Manual page 28

XE210C Hydraulic Excavator
Safety rules for moving

Do not exceed the maximum permissible load when using the machine in order to prevent that the
machine is unstable because of overload and avoid
the damage of the working device.

When moving on the flat ground, taking back the
working device and the bottom of the bucket must
be kept 40 to 50cm above the ground.

When moving on the rough ground, move slowly
and do not swerve to avoid roll-over. If the
working device touches the ground, the machine
may lose balance and be damaged.

When moving on the rough ground or the abrupt
slope, turn off (cancel) the automatic speed
reducing switch, if the machine is equipped with the automatic speed reducing device. If the
automatic is turned on, the rotate speed of the engine is increased, and the moving will be suddenly
accelerated.

Avoid moving on the barrier as far as possible. If
the machine has to move on the barrier, make the
working device close to the ground and move
slowly.

When moving or carrying out operation, keep a
certain safety distance from person or building to
avoid collision.

When passing the bridge or building, firstly check
up if the structure is strong enough to support the
weight of the machine. When moving on the road, consult relevant department to inspect and then
comply with their guidance.

When operating in a tunnel, under a bridge, a wire, or in other place with limited height, operate
slowly, and especially avoid the working device from touching anything.
Operating and Maintenance Manual 28
Moving state
行走状态
40-50cm
（16-20in）