Power-Up Procedure - Cisco AS5400XM Quick Start Manual

Power-Up Procedure

Perform this procedure to power up your Cisco universal gateway and verify that it goes through its initialization and self-test.
When this is finished, the Cisco universal gateway is ready to configure.
To view the boot sequence through a terminal session, you must have a console connection to the Cisco universal
Note
gateway before it powers up. To connect to the console, see the "Connect a Console Terminal" section on page 16.
Step 1 Move the power switch to the ON position. The system board OK LED should come on, and messages will begin to
appear in your terminal emulation program window.
Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are interpreted
Caution
as the first command typed when the messages stop, which might cause the universal gateway to power down and
start over. It takes a few minutes for the messages to stop.
A Cisco AS5350XM or Cisco AS5400XM universal gateway with the maximum number of packet voice data
Note
modules, version 2 (PVDM2) modules installed can take up to six minutes to boot from power-on to system ready.
The messages displayed depend on the Cisco IOS software release and on the cards that are installed in your system.
Note
The screen displays in this section are for reference only and might not exactly match the messages on your console.
The messages look similar to the following:
System Bootstrap, Version 12.3(12r)PI6, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2004 by cisco Systems, Inc.
AS5400XM platform with 524288 Kbytes of main memory
Self decompressing the image :
################################################################################################################
#################################################################################################### [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, 5400 Software (C5400-JS-M), Version 12.3(14)T,
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Sat 29-Jan-05 02:10 by yiyan
Image text-base: 0x60011068, data-base: 0x61F80000
Cisco AS5400XM (BCM) processor (revision 0x21) with 393215K/131072K bytes of memory.
Processor board ID JAB082904P4
SB-1 CPU at 750MHz, Implementation 1025, Rev 0.3, 256KB L2 Cache
32
RELEASE SOFTWARE (fc1)