Cisco AS5400XM Quick Start Manual page 47

For CE1 ISDN PRI—If you do not specify the time slots, the specified controller is configured for 30 B channels
Note
and 1 D channel. B channel numbers range from 1 to 31; channel 16 is the D channel for E1. Corresponding
serial interface numbers range from 0 to 30. In commands, the D channel is interface serial slot/port:15—for
example, interface serial 1/0:15.
Step 6 Return to privileged EXEC mode:
Gateway(config-controller)# Ctrl-Z
Gateway#
Tip To save the gateway configuration, save it to NVRAM. See the "Saving Configuration Changes" section on page 60.
Verifying Interface Configuration
To verify that you have configured the interfaces correctly, enter these commands:
• Enter the show controller t3 command and specify the slot and port numbers. Verify that the controller is up and that you
do not have excessive errors; otherwise, your controller might go down frequently. This could indicate switch problems.
Gateway# show controller t3 1/0
T3 1/0 is up.
Applique type is Channelized T3
No alarms detected.
MDL transmission is disabled
FEAC code received:No code is being received
Framing is C-BIT Parity, Line Code is B3ZS, Clock Source is Internal
Data in current interval (270 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
0 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Total Data (last 32 15 minute intervals):
0 Line Code Violations, 0 P-bit Coding Violation,
0 C-bit Coding Violation, 0 P-bit Err Secs,
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs,
0 Unavailable Secs, 0 Line Errored Secs,
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
• Enter the show controller t1 command and specify the slot and port numbers:
Gateway# show controller t1 1/0
T1 1/0 is up.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Version info of slot 1: HW:768, PLD Rev:4
Framer Version:0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x041,
Board Hardware Version 3.0, Item Number 73-4089-03,
Board Revision 05, Serial Number JAB99432626,
PLD/ISP Version 0.1,
Framing is ESF, Line Code is B8ZS, Clock Source is Line.
Data in current interval (264 seconds elapsed):
3 Line Code Violations, 1 Path Code Violations
Manufacture Date 11-Nov-1999.
47