Cisco AS5400XM Quick Start Manual page 35

Configure Vines? [no]:
Configure XNS? [no]:
Configure Apollo? [no]:
Configure bridging? [no]:
Async lines accept incoming modems calls. If you will have
users dialing in via modems, configure these lines.
Configure Async lines? [yes]:
Async line speed [115200]:
Will you be using the modems for inbound dialing? [yes]:
Would you like to put all async interfaces in a group and configure
them all at one time ? [yes]:
Allow dial-in users to choose a static IP address? [no]:
Configure for TCP header compression? [yes]:
Configure for routing updates on async links? [no]:
Enter the starting address of IP local pool? [X.X.X.X]: 10.1.2.1
Enter the ending address of IP local pool? [X.X.X.X]: 10.1.2.59
You can configure a test user to verify that
your dial-up service is working properly
Would you like to create a test user? [no]:
Will you be using the modems for outbound dialing? [no]:
Enter the letter corresponding to the ISDN switch type that matches your telco switch type, or press Enter to accept the
Step 9
default:
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [b]:
Next, you will be prompted to configure controllers.
These controllers enable users to dial in via ISDN or analog modems.
Step 10 Enter yes to allow users to dial in using ISDN or analog modems:
Do you intend to allow users to dial in? [yes]:
There are 2 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller T3 0,1...etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Whereas CAS configuration
will be configured individually for each controller.
Step 11 Enter the number of controllers that you will be using for the PRI configuration, or press Enter to configure all
controllers:
Enter # of controllers, you will be using for PRI configuration [2]:
Configuring controller parameters:
Step 12 Press Enter for every slot, port, and channel:
Configuring controller t1 3/0:
Configuring PRI on this controller.
Configuring controller t1 3/1:
Configuring PRI on this controller.
in software corresponds to Port 0,1...etc
35