Cisco AS5400XM Quick Start Manual page 41

Define the slot/port group range of the interface. The range that you specify depends on the number of asynchronous
Step 4
interfaces you have on your gateway. If your gateway has 108 asynchronous interfaces, you can specify group-range
1/1 1/107.
Gateway(config-if)# group-range slot/port slot/port
Building configuration...
Gateway(config-if)#
Return to privileged EXEC mode:
Step 5
Gateway(config-if)# Ctrl-Z
Gateway#
To save the gateway configuration, save it to NVRAM. See the "Saving Configuration Changes" section on page 60.
Tip
Verifying the Group Interface Configuration
To verify your group interface configuration, enter the show interface async command in privileged EXEC mode:
Gateway# show interface async 4/0
Async4/00 is down, line protocol is down
modem(slot/port)=4/0, state=IDLE
dsx1(slot/unit/channel)=NONE, status=VDEV_STATUS_UNLOCKED
Hardware is Async Serial
MTU 1500 bytes, BW 115 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation SLIP, loopback not set
DTR is pulsed for 5 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/10/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/32 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 86 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
If you are having trouble, check for errors as well as local and remote addresses. Enter the show async status command in
privileged EXEC mode:
Gateway# show async status
Async protocol statistics:
Int Local
1/00 42.1.1.1
1/01 192.168.10.100
1/02 192.168.10.100
1/03 192.168.10.100
1/04 192.168.10.100
1/05 192.168.10.100
Remote Qd InPack
None 0 0
None 0 0
None 0 0
None 0 0
None 0 0
None 0 0
OutPac Inerr Drops MTU
0 0 0 1500
0 0 0 1500
0 0 0 1500
0 0 0 1500
0 0 0 1500
0 0 0 1500
41