© ANITA
14. Thread holder:
Fig. 34 shows position of the thread holder (6). This device is activated by parameter 32.
Default value is 80
15. Needle cooling:
Fig. 34 shows position of nozzle (7) used for needle cooling. This function is activated by parameter
31.
Fig. 35 shows valve (3) for adjustment of the amount of air supplied to the cooling nozzle.
16. Lock of the feeding clamp:
The feeding clamp is connected with the X-axis movement mechanism by means of lock (1), see Fig.
35. For correct function it is necessary to connect the hoses into pneumatic nipples (4).
It is also necessary to lubricate the locks by spray lubricant with teflon as indicated by arrow (2)
approximately once a week.
MP03200EN_180810
Fig. 34
Fig. 35
25