D3. BOBBIN FIXING AND HOOK THREADING
Attention! Danger of injury!
Switch the main switch off and wait for the motor stopping.
1. Tilt the flap ①, grip it and pull the bobbin case ② out of the hook.
2. Put the bobbin ③ in the bobbin case with the thread end ④ oriented according to the picture.
3. Draw the thread end ④ through the slit ⑤, pull under the spring ⑥ and pull into the slit ⑦.
Insert the case ② back in the hook and press it down in the arrow direction ⑧ till the lock inside
the case clicks and secures it against falling out.
4. Make one stitch without the sewn material, and drawing the thread upper end, pull the hook
thread end outwards above the throat plate.
D4. UPPER THREAD THREADING
12
Let the take up lever at its highest position. Then threading as
shown in picture. Unwind a sufficient portion of thread, and pass
it through the thread guide ① and ②, then lead it through the
tension assembly ⑥ and thread take up spring ⑤, thread guides
⑦, ④ and ③ into the thread take up lever. Then downwards
through the thread guide ④ and the lower thread guide ⑧ to
the thread guide ⑨ on the needle bar, and to the needle. Insert
it into the needle hole from the front side to the rear side.
GZ-5525 series
© ANITA
MP04600EN_220920