Winding The Bobbin Thread, Adjusting The Thread Tension - Garudan GP-110-147 User Manual

Switch off the machine!
Danger of injury due to unintentional starting of the machine!
• Raise the roller presser 1 and swing it out.
• Loosen screw 2 and insert the needle as far as possible. The long groove must face to the
left （Single Needle).
• Loosen screws 2 and insert the needles as far as possible. the long groove of the left needle is
facing right, and that of the right needle is facing left（Double Needle）.
• Tighten screws 2 and swing roller presser 1 back into position.

6.02 WINDING THE BOBBIN THREAD, ADJUSTING THE THREAD TENSION

• Place an empty bobbin 1 onto bobbin shaft 2.
• Thread the bobbin in accordance with the pictures and wind it anti-clockwise around bobbin 1 a
few times.
• Switch on the bobbin winder while at the same time pressing bobbin winder spindle 2 and lever
3.
MP02800EN_180126
Fig. 11
© ANITA
10