Intercom Calls; Placing Intercom Calls - Inter-Tel AXXESS User Manual

Standard & Basic Keyset User Guide

INTERCOM CALLS

Placing Intercom Calls

The Basics
To place an intercom call:
— While on or off hook, dial an extension number.
— If your call goes through handsfree to the called keyset's speaker, speak after you
hear a double tone.
If you hear continuous ringing, wait for the call to be answered.
— When finished, hang up.
Options
If you want to place a non-handsfree call that will ring at the other keyset until
answered:
— Press before dialing the extension number. (This step is not necessary if you
#
programmed your keyset for the Ring Intercom Always feature described on
page 31.)
If there is no answer, you can do any of the following:
— You can leave a message: Press
center to answer. (See page 15 for more Message options.)
— You can stay on the line and wait for the phone to become available: When you
hear busy signals, do not hang up. After a system timer expires, you hear music
until the phone is available. (You cannot do this if the called phone is in do-not-
disturb mode.)
— You can use the "Off-Hook Voice Announce" feature (if the called keyset is
enabled for it): This allows you to talk to the keyset user on his or her handsfree
speakerphone, even though the user already has a call in progress on the handset.
Do not hang up. After the busy signals stop, you are automatically connected and
may speak. (If you hear music, or if the phone is in do-not-disturb mode, your
off-hook voice announce call will not go through.)
. Then hang up OR wait for the message
MSG
8
Inter-Tel AXXESS