User-Programmable Feature Keys - Inter-Tel AXXESS User Manual

Standard & Basic Keyset User Guide

User-Programmable Feature Keys

Depending on how your system is programmed, some of your feature keys may be
designated as "user-programmable." If so, you can program them with any of the
feature codes listed on the back of this user guide. (Station Speed-Dial keys require
special programming, as described in the last section below.)
To program a user-programmable feature key:
— While on hook, dial
— Press the feature key you want to program.
— Dial the feature code you want to store under that key. (Refer to the back of this
guide for default feature codes.)
To return all feature keys to their original default values:
— While on hook, dial
To display the current feature key values:
— While on hook, dial
— Press the feature key(s) you want displayed.
— Press
SPKR
To change a user-programmable feature key into a Station Speed-Dial key:
Note: Station Speed-Dial keys created using this procedure are not the same as
the STN SPDL feature key found on some keysets. To use the STN SPDL feature
key, see page 20.
— While on hook, dial
— Press the feature key you want to change into a Station Speed-Dial key.
— Dial
3 8
— When the display asks for a number, dial a digit 0–9. This is the station speed-
dial number "location."
— Label the corresponding key on your keyset with the station speed-dial location
number (0–9) and the extension number or outside telephone number that will be
stored there. You can now use the procedure outlined on page 19 to program and
use the Station Speed-Dial key.
.
3 9 7
.
3 9 5
.
3 9 6
to hang up.
.
3 9 7
.
2
6
Inter-Tel AXXESS