Table of Contents
Advertisement
Quick Links
Submersible Sump / Effluent Pump
IMPORTANT!
Read all instructions in this manual before operating pump.
As a result of Crane Pumps & Systems, Inc., constant product improvement program,
product changes may occur. As such Crane Pumps & Systems reserves the right to
change product without prior written notification.
A Crane Co. Company
420 Third Street
Piqua, Ohio 45356
Phone: (937) 778-8947
Fax: (937) 773-7157
www.cranepumps.com
BARNES
BARNES
INSTALLATION MANUAL
®
Series: SP75X
3/4 HP, 3450 RPM, 60 Hz.
83 West Drive, Bramton
Ontario, Canada L6T 2J6
Phone: (905) 457-6223
Fax: (905) 457-2650
Form No. 115343-Rev. J
Advertisement
Table of Contents
Related Manuals for Barnes SP75X Series
Summary of Contents for Barnes SP75X Series
- Page 1 BARNES BARNES ® INSTALLATION MANUAL Submersible Sump / Effluent Pump Series: SP75X 3/4 HP, 3450 RPM, 60 Hz. IMPORTANT! Read all instructions in this manual before operating pump. As a result of Crane Pumps & Systems, Inc., constant product improvement program, product changes may occur.
-
Page 2: Safety First
Other brand and product names are trademarks or registered trademarks of their respective holders. ® Barnes is a registered trademark of Crane Pumps & Systems, Inc. 2003, 8/05, 5/06, 6/06, 9/06 Alteration Rights Reserved... -
Page 3: Pump Specifications
PUMP SPECIFICATIONS: DISCHARGE ....... 1½” NPT, Female, Vertical MOTOR: Design ..... Oil Filled LIQUID TEMPERATURE ..104°F (40°C) Continuous Insulation ..Class B MOTOR HOUSING ..... Cast Iron SINGLE PHASE ....Permanent Split Capacitor (PSC) PUMP STRAINER ....Thermoplastic Includes Thermal Overload IMPELLER: Protection in motor Design .... -
Page 4: Section B: General Information
Congratulations! You are the owner of one of the finest (508mm)minimum to allow the pump and switch to operate pumps on the market today. Barnes® Pumps are products without restriction. The float switch should not come in engineered and manufactured of high quality components. -
Page 5: Section D: Service And Repair
SECTION D: SERVICE AND REPAIR Manual WARNING ! - DO NOT overfill oil. Overfilling of Automatic motor housing with oil can create excessive and dangerous hydraulic pressure which can destroy the pump and create a hazard. Overfill- ing oil voids warranty. D-1) Bottom Plate: Remove screws, and remove bottom plate from volute and remove volute. Clean and examine impeller. If impeller vanes are clogged, or it is excessively worn or broken, the impeller should be replaced. -
Page 6: Section: E Warranty Repair
E-2 Part Number: The part number consists of a six (6) digit number, which appears in the catalog. A one or two letter suffix may follow this number to designate the design configuration. This number is used for ordering and obtaining informa- tion. -
Page 7: Troubleshooting
TROUBLE SHOOTING CAUTION ! Always disconnect the pump from the electrical power source before handling. If the system fails to operate properly, carefully read instructions and perform maintenance recommendations. If operating problems persist, the following chart may be of assistance in identifying and correcting them: MATCH “CAUSE”... -
Page 8: Returned Goods
IMPORTANT! WARRANTY REGISTRATION IMPORTANT! WARRANTY REGISTRATION Your product is covered by a warranty: Your product is covered by the enclosed Warranty. www.cranepumps.com/downloadables/CATALOGS_OIPMs/Warranty/24MonthWarranty.pdf If you have a claim under the provisions of the warranty, contact your local If you have a claim under the provision of the warranty, contact your local Crane Pumps &...