Installing A Floppy Drive; Removing A Disk Filler Panel - HP Visualize c160 Owner's Manual

B_configure.doc 107 Tue Jul 2 15:27:17 1996
Figure 30

Installing a Floppy Drive

Perform the following procedure to install a floppy drive in the disk tray:
1 Remove the disk filler panel from the bottom location of the bezel by using a coin
or other flat, blunt object to pry it from the front, as shown in Figure 30.

Removing a Disk Filler Panel

2 Reach into the storage bay and locate the power and data cables for the floppy
drive.
Refer to the cable routing label on the storage tray. See Figure 31.
3 Connect the cables to the drive.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
107