B_configure.doc 122 Tue Jul 2 15:27:17 1996
Changing Your Workstation's Hardware Configuration
Installing Additional memory
Installing Additional memory
Take a moment to read over the following important notes about installing
memory.
•
Before you attempt to install additional memory modules in your C160L work-
station, use the procedure described in Appendix D, "The Boot Console Inter-
face," to determine the current memory configuration for this workstation.
•
Read over the steps involved in installing memory modules before you begin.
•
You must insert memory modules in pairs of equal size.
•
Modules must be inserted in the lowest numbered memory pair first, then in nu-
merical order. For example, install memory in 0A and 0B first, then 1A and 1B,
2A and 2B, and 3A and 3B. Refer to Figure 36 for memory pair numbering and
Table 19 for allowable memory configurations.
location. Refer to
•
When you have finished installing additional memory modules, use the Boot
Console Interface to verify that they are seen by the workstation.
122