Preparing Your Workstation - HP Visualize c100 Install Manual

Preparing Your Workstation

Preparing Your Workstation
Before starting the upgrade, use the following procedure to prepare the
workstation:
1 The workstation must be running HP-UX 10.20 or later to accommodate the
NOTE: Updating the operating system takes some time to perform. Please backup your
system before updating.
2 Determine the workstations LAN ID with the lanscan command by entering the
3 Logout of your system and enter a no windows command line session as follows:
4
C200 upgrade. If the workstation is running a version of HP-UX lower than
10.20, update the operating system software before continuing.
following command:
/usr/sbin/lanscan
The output is similar to the following:
Hardware Station
Path Address
2.0.2 0x08000970ECC0 0
After you install the new CPU board or I/O board and power on the system for
the first time, you will be prompted for the LAN ID. Record the LAN ID here.
You will need it after installing the new system board:
EnterLAN ID ___________________-_____________________
You must supply the dash (-) between the first six digits and the last six digits.
Using the above output example, the LAN ID is 080009-70ECC0
HP VUE: At the login window, select Options, then select No Windows.
HP CDE: At the login window, select Option, then select
Command Line Login.
Dev Hardware Net-Interface
lu State NameUnit State ID
UP lan0 UP
NM Encapsulation Mjr
Methods Num
4 ETHER 52