Step 1—Preparing the workstation
Your workstation documentation includes instructions for preparing the workstation for component
installation.
To prepare the workstation for component installation:
1.
Power down the workstation.
2.
Disconnect power from the workstation.
3.
Remove the chassis access panel.
For product-specific information, refer to the Service and Technical Reference Guide for your HP
workstation at http://www.hp.com/support/workstation_manuals.
Step 2—Installing the eSATA adapter
1.
To install the eSATA adapter, release the PCI retainer levers by first pressing down and then out
(1) on them, and removing the applicable PCI slot cover (2) where the eSATA adapter is to be
installed.
NOTE:
Figure 1
4
HP eSATA PCI cable kit installation
The eSATA adapter card can be installed in any unused PCI slot.
Removing the slot cover
ENWW