Installing Option Boards - HP Visualize c100 Install Manual

Installing Option Boards

Installing Option Boards
NOTICE: Any option boards that are supported by the new C200 system should be
installed in the same slot number in the new main tray that they were
installed in the old main tray.
If you are installing a graphics adapter, read and understand the information
in the next section titled "Graphics Adapter Considerations", before continu-
ing. Otherwise skip to the subsection titled "Option Board Installation".
Graphics Adapter Considerations
If you are installing a graphics option, read the information in this section
first.
Graphics Paths
graphics0 is the built-in 8-plane graphics adapter.
graphics1 through graphics4 are graphics adapters installed in option slots 1
through 4.
When a dual display graphics adapter (an adapter which has two video out-
put connectors) is installed, the video connector on the left (when looking at
the system from the rear) is graphicsNA, and the video connector on the
right is graphicsNB, where N is the slot number in which the graphics
adapter is installed.
For example, a Dual Visualize Enhanced Graphics Card (A4451A) installed
in option slot 3 would be graphics3A and graphics3B.
15