Download Print this page

Step 1-Preparing The Workstation - HP Workstation xw4000 Hardware Installation

Rack mount tray installation
Hide thumbs

Advertisement

Step 1—Preparing the workstation
NOTE:
All illustrations are examples only. Workstation models vary. For product-specific information,
see the service guide for your HP workstation at
before beginning installation.
To prepare the workstation for component installation:
1.
Power down the workstation, and then disconnect the power cord.
2.
Power down all external devices, and then disconnect them from the workstation.
Step 2—Attaching the rack mount tray to the workstation
1.
Using a T-15 Torx screwdriver, remove the two middle chassis screws
workstation and save them for reuse.
Figure 1
2.
To install the workstation in the tray:
a.
Lower the workstation
b.
Guide the front bezel of the workstation
Figure 2
ENWW
Removing the chassis screws
into the tray
Placing the workstation onto the tray
http://www.hp.com/support/workstation_manuals
.
2
under the lip of the tray
Step 1—Preparing the workstation
from the rear of the
.
3

Advertisement

loading

  Related Manuals for HP Workstation xw4000