Replacing The Hard Disc Drive With Two 2.5-Inch Drives - HP Compaq Pro 6300 Hardware Reference Manual

13.
To replace the access panel, set the panel on the back of the computer, slightly above the stand,
and slide it down into place.
Figure 2-34
14. Reconnect the power cord and external devices.
15.
Lock any security devices that were disengaged when the access panel was removed.
16.
Turn on the computer.

Replacing the Hard Disc Drive with Two 2.5-inch Drives

The hard disc drive is located behind the access panel on the left side of the computer (when viewed
from behind). The drive is housed in a removable cage.
If you choose to install two optional 2.5-inch solid state drives (SSDs) or self-encrypting drives (SEDs),
you will need a drive adapter. The drive adapter may be part of the drive kit, or you may need to
purchase it separately. It is recommended that you purchase a drive kit with adapter and cable from HP
that is designed to operate with the computer.
1.
Remove all removable media, such as compact discs or USB flash drives, from the computer.
2. Turn off the computer properly through the operating system, then turn off any external devices.
3.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
4. Remove/disengage any security devices that prohibit opening the computer.
5.
Place the computer face down on a soft flat surface. HP recommends that you set down a blanket,
towel, or other soft cloth to protect the bezel and screen surface from scratches or other damage.
Replacing the Access Panel
Regardless of the power-on state, voltage is always present on the system board as
Replacing Drives
33