PCI #1
PCI #2
PCI #3
PCI #4
PCI #5
ISA #1
ISA #2
WOL connector (already connected for models
with a preinstalled LAN card)
Vectra VE 8 (Pentium II / Celeron Processor) — Replacing Hardware Components
Replacing an Accessory Board
Replacing an Accessory Board
1 Remove the computer's cover (page 3).
2 Remove any cables connected to the accessory board.
3 Remove the screw that holds the old board in place.
4 Hold the old board firmly and carefully pull it out.
5 Aligning the new board carefully, slide it into position,
then press it firmly into the slot and tighten the
retaining screw.
6 The accessory board may need a special connection, such as:
a Network cable to the WOL (Wake On Lan) connector.
b Sound cable to the CD-ROM drive.
7 Replace the cover (page 4).
10
English
CD audio connector.
Connect the
CD-ROM sound
cable between this
connector and the
CD-ROM drive.