Replacing The Cover - HP Vectra VE6 8 Hardware Manual

Vectra VE 8 (Pentium II / Celeron Processor) — Replacing Hardware Components
Removing and Replacing the Cover

Replacing the Cover

1 Make sure that you have installed all your accessories and that all
internal cables are properly connected and safely routed.
2 a Standing at the back of the PC, lower the cover onto the
PC chassis (aligning the rails on the inside edges of the
cover with the sides of the PC chassis), and firmly slide the cover
forwards into position.
b Lower the cover onto the PC chassis and slide it into
position. Make sure that the two guides at the bottom of
the cover slide into the two rails at the base of the chassis,
and that the guides at the front of the cover slide into the rails at
the front of the chassis.
3 Tighten the three thumb screws at the back of the PC.
Step 2
Step 3
4 Reconnect all cables and power cords.
4 English
Step 2
Step 3