HP Vectra VE6 8 Hardware Manual page 8

Vectra VE 8 (Pentium II / Celeron Processor) — Replacing Hardware Components
Removing the Status Panel
Step 3a
4 Replace the Status Panel:
a Insert the status panel cable through the opening and connect it
to the 'Front Cable Connector' on the system board.
b Ensure that the status panel is positioned the right way up.
c Align the bottom two notches of the status panel with their
corresponding slits in the chassis, and then push into place.
d Carefully push down on top of the status panel, then push into
position.
5 Replace the front bezel and cover. Reconnect all cables and power
cords.
8 English
Step 3b