Table of Contents
Advertisement
8
Design and Function
The body of the welding gun consists of a sturdy two-part plastic housing (1).
The control cable and the solenoid cable (2) are connected through the welding
gun handle to the welding gun. The welding cable (3) is externally connected.
Positioned at the front of the welding gun there is the chuck where the welding ele-
ments of the welding gun are manually fed.
A leg assembly with foot piece, where the ceramic ferrule grip is inserted, is used to
position the welding gun vertically.
The springy welding elements are projecting out of the ceramic ferrule grip with
ceramic ferrule. In this way, they can be positioned above the aluminum ball or the
cone.
At the front of the welding gun handle, the welding gun trigger (4) is installed. It is
used to trigger the welding process.
The serial number (5) is stamped on the welding gun handle.
The protection cap (6) is used to cover the damper.
Type plate
The type plate contains the following information:
– Manufacturer
– Type
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
5
4
3
8 Design and Function
1
2
19
Advertisement
Table of Contents
