13.3
Adjusting the Lift Scale
The lift scale can only be adjusted with connected and switched on stud
welding unit.
Observe the safety instructions in the operating manual of the connected
stud welding unit.
Refer here to the operating manual of your stud welding unit.
1
Screw off the cap at the rear.
Now screw in the lift up to the stop by turning clockwise.
Now screw out the lift step by step by turning counter-clockwise.
Push the welding gun trigger and check if lift is triggered.
Repeat this procedure until a lifting motion at the chuck is visible.
Lock this position with an allen key (size 8).
Loosen both slotted screws.
Adjust the scale wheel by turning and setting the zero position onto the marking.
Then tighten the slotted screws.
Screw on the cap again.
Now the scaling 'Lift' is adjusted.
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
3
4
2
5
13 Maintenance and Care
1 - Cap
2 - Marking
3 - Scale wheel
4 - Slotted screw
5 - Allen key size 8
37