8
Design and Function
The body of the welding gun consists of a sturdy two-part plastic housing (1).
The control cable (2) and the welding cable (3) are connected through the welding
gun handle to the welding gun.
Positioned at the front of the stud welding gun is a double nipple (5) used to fix the
manual chuck.
At the front of the stud welding gun, the tripod leg guidance (7) is installed. Here
the leg assembly is mounted.
The protection cap (6) is used to cover the damper.
At the rear (under the cap (8)), there is the mechanism for lift adjustment.
At the front of the welding gun handle, the welding gun trigger (4) is installed. It is
used to trigger the welding process.
The serial number is stamped on the welding gun handle.
Type plate
The type plate contains the following information:
– Manufacturer
– Type
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – full or partial reproduction subject to prior approval of the manufacturer
5
6
7
4
8 Design and Function
8
1
2
3
19