8
Design and Function
The body of the welding gun consists of a sturdy two-part plastic housing.
The control cable (2) and the welding cable (2) are connected through the wel-
ding gun handle (1) to the welding gun.
Positioned at the front of the welding gun are the welding piston and the retaining
nut (5) used to fix the manual chuck.
At the front of the welding gun, the foot ring is installed. Three legs (4) can be used
to position the welding gun straight.
At the front of the welding gun handle, the welding gun trigger (3) is installed. It is
used to trigger the welding process.
The serial number can be found on the welding gun handle.
Type plate
The type plate contains the following information:
– Manufacturer
– Type
The serial number is stamped.
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – full or partial reproduction subject to prior approval of the manufacturer
5
4
3
8 Design and Function
1
2
17