Table of Contents
Advertisement
8
Design and Function
The body of the stud welding gun consists of a sturdy two-part plastic housing (1).
The control cable (2) and the welding cable (2) are connected through the welding
gun handle to the stud welding gun.
Positioned at the front of the stud welding gun are the welding piston and the retai-
ning nut (3) used to fix the manual chuck.
At the front of the stud welding gun, the foot ring is installed. Three legs (4) can be
used to position the stud welding gun straight.
At the rear, there is the mechanism for spring force adjustment (5).
At the front of the welding gun handle, the welding gun trigger (6) is installed. It is
used to trigger the welding process.
The serial number (7) is stamped on the welding gun handle.
Type plate
The type plate contains the following information:
– Manufacturer
– Type.
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
8 Design and Function
17
Advertisement
Table of Contents
