Design And Function - HBS A 12-FL Operating Manual

8 Design and Function

8 Design and Function
The stud welding gun A 12-FL is equipped with a fixed lift of 6 mm.
The body of the stud welding gun consists of a sturdy two-part plastic housing (1).
The control cable and the welding cable (2) are connected through the welding
gun handle to the welding gun.
Positioned at the front of the stud welding gun are the welding piston and the retai-
ning nut (3) used to fix the manual chuck.
At the front of the stud welding gun, the leg assembly (4) is installed. Here the leg
guidance is mounted.
At the front of the welding gun handle, the welding gun trigger (5) is installed. It is
used to trigger the welding process.
The serial number is stamped on the welding gun handle.
Type plate
The type plate contains the following information:
– Manufacturer
– Type
16
3
4
5
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – full or partial reproduction subject to prior approval of the manufacturer
1
2