Table of Contents
Advertisement
7
Relay Setting
Set the relay output setting from SC-U1.
The factory default setting is OFF for relay output.
To set the relay setting, press
Caution
Pressing
Alarm output setting
Set the alarm to be output when the measurement value exceeds a certain
value.
The following settings are available.
For operation, refer to the "Universal Transmitter SC-U1 Operation
Manual", "5.4 Relay Setting" and " ◆ Alarm output setting".
When "Display item" P.13 is changed, the output item of the
Caution
channel of relay setting that has set the display item becomes OFF.
Set again if necessary.
Setting item
Trigger
Active Level
Hysteresis High Alarm 0.0 to Active level
Low Alarm 0.0 to (1000 - Active
ON Delay
OFF Delay
The setting unit for the active level is based on the display resolution of the item
set for the display item. (For display resolution, refer to "14 Specifications" P.34)
.
automatically retains the measurement value.
Suspended solids [SS]
High Alarm/Low Alarm
0.0 to 1000
level)
OFF
1 to 120 minutes
OFF
1 to 120 minutes
Setting range
Transparency [Trans.]
0 to 100
0 to Active level
0 to (100 - Active level)
17
Advertisement
Table of Contents
