Table of Contents
Advertisement
9
Adjustment
Adjust and display the measurement values according to usage. In addition, adjust
and display the measurement values according to the environment where used.
To adjust, press
・ Pressing
・ If offset, span, or 2-point adjustment has already been
performed, be sure to initialize the adjustment before
Caution
performing the 2-point adjustment.
・ When "Display item" P.13 is changed, the values of the offset
adjustment, span adjustment, and 2-point adjustment that have
the display item are reset to the factory default values.
Set again if necessary.
Offset adjustment
Set the offset coefficient to add to a
measurement value.
Display the measurement value with
offset-adjusted to any display value.
For 4-20 mA output ("6 4-20 mA Setting" P.15)
and alarm output ("Alarm output setting" P.17),
the adjusted values are applied.
Measurement item [Display]
Suspended solids [SS]
Transparency [Trans.]
Press
1
The measurement item selection display is displayed.
Select [SS TS-1000-D] using
2
TS-1000SP-D is also displayed as
[TS-1000-D].
Use
The adjustment menu is displayed.
22
.
automatically retains the measurement value.
Setting range
-100.0 to 100.0 0.0
-10 to 10
.
, and press
to switch pages.
Factory default setting
0
.
Sensor channel
Display value
after offset
adjustment
Measurement
value
Sensor model
Measurement item
Advertisement
Table of Contents
