Table of Contents
Advertisement
7
Secure the board by replacing the slot cover screw. If you loosened the screws on
adjacent slots, tighten them.
8
If you install a VESA-standard video adapter board* which uses the integrated video
graphics controller, connect the accessory board's cable to the VESA pass-through
connector on the system board.
9
Install any other accessories before replacing the power supply and the cover. Reconnect
all cables and power cords.
*A DOS utility (FCON.EXE) must be run to use the VESA pass-through connector (FCON.EXE is
only available for Windows 3.11 and Windows 95). It is delivered preloaded on your PC's hard disk
and can also be obtained online (refer to "HP BBS Library" in chapter 6).
Advertisement
Table of Contents
