Security Menu Items - HP Vectra XM 5Series User Manual

Integrated Network Interface Submenu (Configuration group)
Setup Item
Integrated Ethernet
Interface
*If an asterisk (*) appears in front of any of these values, then you will see the following message in
the lower part of the screen:
[*] = The device is disabled for security reasons. To enable it,
use the Security/Hardware Protection menu.
(Refer to the Hardware Protection submenu under the Security group.)
Setup Item
Slot #1 Bus Master
Slot #2 Bus Master
PCI IRQ line 1
PCI IRQ line 2
PCI IRQ line 3
PCI IRQ line 4

SECURITY MENU ITEMS

When you select this menu group, a screen similar to the one below will appear.
PhoenixBIOS Setup — Copyright 1985-95 Phoenix Technologies Ltd.
Main Configuration
User Password
Administrator Password
Hardware Protection
Start-up Center
F1 Help
ESC Exit
Default*
[Enabled]
PCI Devices Submenu (Configuration group)
Default*
[Enabled]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
Copyright 1995 Hewlett-Packard Rev. GW.O5.xx
Security
↑ ↑ ↓ ↓
Select Item
← ← → →
Select Menu
Action
Enables or disables the integrated LAN interface.
Action
Enable this option if you need the BIOS to set
the PCI Bus Master bit. This could be necessary
for some older PCI accessory boards.
Select an IRQ number only if necessary (for
example for SCO-UNIX).
Power Exit
F7/F8 Change Value
Enter Select > Sub-Menu
Item-Specific Help
F9 Setup Defaults
F10 Previous Values